Simple Tips To Wire A Dual Voice Coil Subwoofer

There are two ranges of sounds. One is the high range sound and the other is the low range sound. The high range sounds can be handled at speakers in the rear end, dash and door panels of the vehicle. But the lower tones and the bass effects are generally handled by the sub woofer which has got no other substitute. One should ensure that the sub woofers are wired properly. But how to wire dual sub woofer?

The process is very simple and easily followable. The process will obviously require woofers. The amplifier will be connected to the subwoofers using speaker wires. The following paragraphs will discuss on the steps involved in this process.

The first step is to check the impedance of the sub woofer. They come in many ranges of resistances or impedance. Four ohm and two ohm are the most common ranges available. This sub woofer may also be of dual voice coil they don have variations that are unusual. The very common type of sub woofer under using is the four ohm range. And so the plans for wiring are all designed so as to match this kind of sub woofer.

The woofer can be placed either in the cargo area at the rear back or the car’s trunk in the case of models like hatch backs or SUV .There are channels in the amplifiers. Then the amplifier position is located after which the manual is gone through for any kind of procedure to be followed.. To these channels the wire from the sub woofer is connected. The ends of these wires are stripped by an inch.

There are many types of terminals available in an amplifier. The most common type of the amplifier terminal is the”push” terminal. In this type for making a connection you have to press a lever and pass the wire through the hole that appears.

The second method for wiring a sub woofer is to wire a dual subwoofer to a single channel amplifier. Now remove about 0.5 inch of insulation from the ends of the wire. Now take the wire from the positive terminal of the amplifier is connected to the positive terminal of the first sub woofer. Now take the second wire from this terminal and connect it to second sub. Repeat this step with the negative terminals. This method of wiring is termed as “daisy-chaining”.

Check your sub woofers by playing a track of your choice. If you feel that the bass is not good enough check for all the wiring so as to ensure that there is no wrong connection made between negative and positive. Such a wrong wiring may lead to poor sound quality and also make it play out of phase. This should be avoided.

We must realize the fact that people look for the exact feel of music. Music is used to treat certain kinds of diseases. In these cases even a small disturbance may bring a lot of effect on the individual. Modern technology has made components which will make even the most lowest level of music to be heard crystal clear. Subwoofer comes under such an invention which will make us hear the bass types of music. Thus this article on how to wire dual woofers will be very useful for beginners who are in need of it.

Looking to find the best deal on Auto Hifi, then visit www.powernetshop.at to find the best advice on Car audio for you.

Possibly Related Posts:

• Garage Floors And The Proper Covering Alternatives
• Auto Leasing Tricks That Can Cost You Thousands
• GMC Dealers In Utah Help With Leasing Versus Buying Decisions
• Should You Consider Steel Garage Kits?
• Know How To Compare Insurance